Tagra | IP65 | 24V | Essential | Horizontal Bend LED Neon Flex | 10x15mm | 8.0W p/m | 4000K | Sold Per Metre

Specifications:

• Voltage - 24v
• Dimensions - 15mm x 10mm
• LED Type - SMD2835 in Epistar Chip
• Number Of LEDs - 72 Per Metre
• Cut Points - Every 12.5cm
• Max Load - 12m
• LED Distance - 8.33mm
• Power - 5.43W Per Metre
• Lumens - 370 Per Metre
• CRI - >80
• Jacket Type: Dome
• Splashproof, subject to correct installation.
• Min. Bend Diameter - 120mm

 

LED Neon Flex Mini is a new compact version of our Neon Flex tube lighting, at only 15 x 10mm its small size and light weight it is ideal for slimline perfect for single use display applications indoor and outdoor.

 

As the name suggests, it is highly flexible and can be bent to a minimum diameter of 120mm, and can be cut easily to your desired lengths. Maximum Length at any time is 15 metres.

 

Neon Flex can be dimmed via mains dimming, DALI, DMX or RF controllers.

 

Please Note: We are not able to offer refunds on cut lengths of Neon Flex Mini, only for full 50m reels. If you order more than a 1 Metre length of Neon Flex you will receive a continuous run as it is taken from a 50m roll.

 

For a working Neon Flex Mini installation you will need:

 

• Neon Flex Mini LED 
• 1 x Neon Flex Mini Power Cable
• 1 x Neon Flex Mini Connector Pin
• 1 x Neon Flex Mini End Cap
• 1 x 24 volt power supply

 

Heat shrink tube is also highly recommended to seal both the endcap and power cable in order to maintain the splashproof rating.

 

All our neon flex comes with a 1 year guarantee for indoor and a 6 month guarantee for outdoor installations.

 

Dimming Compatibility

• Compatible with dimmers using standard control protocols including DMX, Dali, 0-10V, PWM.
• Compatible with smarthome dimmers including those from Lutron, Loxone, Rayco, Control 4, Lightwave, Wizz, Casambi, Crestron.

 

Driver Requirements:
1 metre > 6w
2 metres > 12w
3 metres > 18w
4 metres > 24w
5 metres > 30w
6 metres > 36w
7 metres > 42w
8 metres > 48w
9 metres > 54w
Up to 12 metres – 80w

 

A 24v LED Transformer is required to power our Neon Flex.

 

Drivers and cabling are not covered by the splashproof rating and therefore must be housed indoors in a dry environment. Splashproof rating applies to the Neon Flex only.

 

all products should be installed by a technically competent person in accordance with BS7671 and all other local regulations.